175
External Power Supply
The external power supply function enables
this vehicle to provide AC power from its
power battery to electrical appliances and
provides temporary power to other electric
vehicles.
Vehicle to Load (V2L)
The external power supply function using
the V2L discharge cable can be set as
follows:
1. Remove the protective cover of the AC
charging port of this vehicle;
2. Plug in the V2L discharging gun to the
AC charging port of this vehicle;
3. Click the following on the multimedia
display: Energy Center → External
Power Supply → Power Supply to
Equipment/Vehicle in sequence to set
the remaining power in percentage for
this external power supply function and
to turn on the external power supply
function.
• Plug/unplug the charging gun vertically
and as careful as possible to prevent
damage to the vehicle and the
appliances that is connected to this
vehicle’s power supply. The rated
amperage for the household electrical
equipment or the transfer cables shall not
be lower than the rated amperage
marked on the power supply equipment.
• Do not use the external power supply
function of this vehicle when the power
battery level of this vehicle is too low.
Otherwise, the vehicle cannot be started
due to low power.
The external power supply equipment
of this vehicle is only used to provide
electric energy output. Do not connect other
external charging equipment or electrical
appliances whose rated power exceeds that
of the power supply equipment, especially if
the external power supply equipment has
been connected to the AC charging port of
this vehicle. Otherwise, it may cause
damage to this vehicle and the external
power supply equipment.
Vehicle to Vehicle (V2V)
If you choose to perform V2V external
discharging, the specification of V2V
discharging cable are as follows:
• If the discharge current is 32 A, use
discharge cable with resistance of 3700
Ω;
• If the discharge current is 16 A, use
discharge cable with resistance of 2700
Ω.
This is helpful for normal use.
Charging and Discharging
To Next Page
Loading...