205
Towing Ring
Precautions When Using Towing
Ring
• Make sure the towing ring is installed
securely and reliably into the towing
mounting hole.
• It is recommended to only mount and use
certified traction bar or traction rope on
the towing ring.
• Do not purposely use the towing ring to
tow this vehicle up to the flat-bed truck.
• Do not purposely use the towing ring to
rescue a trapped vehicle.
When towing this vehicle using the
towing ring, make sure to keep a safe
distance from the towing vehicle.
• Do not use the towing chain/belt on the
towing ring. The towing chain/belt may
be broken, resulting in severe injury or
death.
• Failure to follow the instructions when
towing using towing ring may cause the
parts to break, resulting in severe injury
or death.
Use the towing ring for road rescue
purpose only and shall not be used for
other purposes.
• When using the towing ring, make sure
to use a proper equipment that complies
with the traffic regulations (such as a
rigid towing bar or towing rope), to tow
the vehicle on the ground to the nearest
service outlet in a short distance.
• Do not use the towing ring to tow the
vehicle on off-road or road with
obstacles.
• When towing with a towing ring, both
towing truck and the faulty vehicle must
be on the same center line as far as
possible. Failure to follow the above
instructions may result in vehicle
damage.
Installing Front Towing Ring
1. Take out the towing ring from the
onboard tool kit in the trunk
compartment;
2. Open the cover plate of the mounting
hole on the right side of front bumper;
3. Install the towing ring into the towing
mounting hole and tighten it to ensure
that the towing ring is fully tightened.
In case of Emergency
To Next Page
Loading...