79
Automatic High Beam Control (AHBC)
system indicator will illuminate in white.
When the Automatic High Beam Control
(AHBC) system fails, the Automatic High
Beam Control (AHBC) system indicator will
illuminate in yellow.
When the driver operates the light
combination switch to select and turn
on the high beam, the driver’s selection
prevails.
The Automatic High Beam Control
(AHBC) system is an auxiliary
function of the lamp control. It is
recommended to use this function when
driving on highway, but the system cannot
completely substitute the driver’ response.
The driver should always alert when it is
necessary to switch the high/low beam
according to the requirements of traffic
regulation as well as actual road conditions.
In the following examples, the
Automatic High Beam Control (AHBC)
system does not work or only works with
some limitations, which may require the
driver’s response:
• In bad weathers such as rainstorm,
heavy snow or heavy fog, in which are
not recommended for driving.
• Traffic users (such as pedestrians,
cyclists) with poor illumination, railway or
waterway traffic near the road, and the
road infested with wild animals.
• In the environment with strong reflective
views (such as traffic signs on highways).
• When the front windshield is covered
with fog, dirt or covered by labels and
ornaments.
Lighting
To Next Page
Loading...