20
Seat Belt Pretensioner
Seat belt pretensioner is available for front
seat belt. In the event of a vehicle collision
and the seat belt device reaches the trigger
condition, the seat belt will be tensioned to
keep the passengers safe. The pretensioner
can only work once. After a collision, it is
necessary to contact an authorised
PROTON e.MAS service outlet for a new
pretensioner, and other seat belt system
components may need to be replaced.
Seat Belt Unfastened Reminder
This vehicle is equipped with an unfastened
seat belt reminder function for the driver and
front and rear passengers. When the seat
belt unfastened alarm is triggered, the seat
belt unfastened warning lamp
on the
combination instrument display will
illuminate in different states, and the
combination instrument display will show
the seat with the seat belt unfastened.
When the power system is activated, the
warning lamp illuminates if the driver, front
or rear passenger seat belt is not fastened.
When the vehicle speed is between 10 ~ 25
km/h or the driving distance forward is more
than about 300 metres, this lamp will flash
slowly with a warning tone; when the vehicle
speed is more than 25 km/h, this lamp will
flash quickly with a warning tone; when the
vehicle speed is more than 10 km/h, the
lamp will flash with a warning tone if the seat
belt is unfastened. And the lamp will turn off
and the warning tone will disappear until the
seat belt is fastened in the corresponding
position.
• Fastening seat belt properly can lower
the risk of being hurt at emergency
braking and traffic accidents. Thus, the
driver and passengers should all fasten
seat belts properly during driving.
• Please pay attention to the illuminated
warning lamp on the combination
instrument display; otherwise, serious
personal injury and property damage will
be caused.
Safe Travel
To Next Page
Loading...