208
gauge. The minimum pressure is 1.8
bar, and maximum pressure is 3.2 bar;
If the tyre pressure reading is too
high, press the air release valve to
reduce the tyre pressure.
If the tyre pressure reading stays
lower than 1.8 bar, this indicates that
there is a big air leakage. Stop pumping air
into the tyre and contact authorised
PROTON e.MAS service outlet for
assistance.
10. Turn off the electric air pump and
remove the 12V power plug from the
12V power socket;
11. Remove the air hose of electric air pump
from the air inlet valve of tyre repair fluid
tank;
12. Immediately drive the vehicle for 3
kilometers and maintain the driving
speed not more than 80 km/h to let the
tyre repair fluid evenly seal the tyres
from inside.
Once above procedures have
completed, do as follows:
• The driving speed of the vehicle shall not
exceed 80 km/h.
• The driving distance of the vehicle shall
not exceed 200 km.
• Drive to the authorised PROTON e.MAS
service outlet as soon as possible for tyre
repair or replacement.
Overheating of Drive Motor
or Motor Controller
Overheating of the drive motor or motor
controller actually refers to the condition
when the coolant temperature becomes too
high, which should be handled according to
the following procedure:
1. Drive the vehicle safely off the road,
stop and turn on the hazard warning
lamp; then shift the gear into Park (P)
position and press the electric parking
brake (EPB) switch on the multimedia
display. Turn off the air conditioning
system.
2. Visually check whether there is any
significant coolant leakage under the
radiator, hose or vehicle. It is normal if
there are water drops from the working
air conditioner.
3. If the coolant leaks, stop using the
vehicle immediately. Please contact
authorised PROTON e.MAS service
outlet for maintenance as soon as
possible.
4. If no obvious coolant leak is found,
check the coolant level in the coolant
expansion tank. If it has dried up, fill the
coolant expansion tank with coolant to
about half of the tank while the vehicle
is started.
5. If there is no coolant leakage and the
coolant level in the expansion tank is
normal, please contact PROTON
e.MAS service outlet for maintenance
as soon as possible.
6. When the coolant temperature is
normal, recheck the coolant level in the
expansion tank again. Add to half if
In case of Emergency
To Next Page
Loading...