206
Installing Rear Towing Ring
1. Take out the towing ring from the
onboard tool kit in the trunk;
2. Take a flat tip screwdriver, wrap it in
cloth and use it to pry off the cover plate
of the towing mounting hole on the left
side of the rear bumper;
3. Install the towing ring into the mounting
hole and tighten it with a tool to ensure
that the towing ring is fully tightened.
The towing ring should be placed
back in the onboard tool kit when it is
not in use.
Quick Tyre Repair
Park the vehicle on a solid flat surface
where there is no traffic hazard and
safe for you to repair your tyres. Turn on the
hazard warning lamp, and place a triangle
warning board behind the vehicle about 50
m to 100 m away on normal road and 150 m
away on the highway; to alert other vehicle
on the emergency condition of the vehicle.
• The tyre repair tool is only suitable for
sealing tyres that punctured in the tread
area. The tyre repair tool cannot be used
to seal the tyre that has large crack, split
or similar damage.
• The tyre repair tool must be replaced if it
has reached its expiry date, or after been
used for emergency tyre repairs.
• The tyre repair tool must be stored out of
the reach of children.
Quick Tyre Repair Tool
The quick tyre repair tool is in the onboard
tool kit in the trunk compartment.
In case of Emergency
To Next Page
Loading...