Proton e.MAS 7 - Lighting; Light Combination Switch

75
Light Combination Switch
Operation of Light Combination
Switch
Switching between High/Low Beam
To turn on high beam, when the low beam is
turned on, push the light/wiper control lever
in the A direction to the 1st notch position;
the high beam will turn on.
Push the light/wiper control lever in the B
direction to either position; the high beam
will turn off.
When the intelligent high beam control
system is turned on, push the light/wiper
control lever in the direction B to the
endmost position, and the high beam will
turn off.
Flashing the High Beam
Push the light/wiper control lever in the B
direction to either position and immediately
release the lever; the high beam will flash.
The high beam can be flashed repeatedly
by repeating the same step.
Position Lamp
Click the following on the multimedia
display: Vehicle Settings → Lights →
Exterior Lighting; then click on the position
light switch in the interface and a prompt
interface will pop up. In the interface, drag
the slider to confirm and turn on the position
light.
Low beam
Click the following on the multimedia
display: Vehicle Settings → Lights →
Exterior Lighting ; then click on the low
beam switch in the interface and a prompt
interface will pop up. In the interface, drag
the slider to confirm and turn on the low
beam.
Lighting