181
“fizz” sound, open the pressure cap
after the “fizz” sound disappears.
The “fizz” sound indicates that a
pressure still exists.
2. Continue turn the pressure cap
counterclockwise and remove it.
3. Slowly fill in coolant until the coolant
level in the coolant expansion tank
reaches the position between the MAX
and MIN lines and the coolant level no
longer drops.
4. Start the vehicle, turn on the A/C
system, and let the remaining air of the
coolant system being removed through
the operation of the electric water pump;
5. Observe drops of coolant in the coolant
expansion tank and replenish the
coolant in time. The coolant level in the
coolant expansion tank should be kept
between the MAX and MIN marks;
6. Observe the vent under the pressure
cap of coolant expansion tank. Wait until
the coolant continuously flows out of the
vent and the coolant level in expansion
tank no longer drops. Tighten the
pressure cap to complete the coolant
refilling process.
Only refill with certified ethylene
glycol-type coolant. Damage or failure
caused by the use of low quality coolant or
non-compliant coolant mixture is not
covered by the warranty.
Brake Fluid
Check the brake fluid level from time to time.
The brake fluid level should be between
MAX and MIN marks.
If the brake fluid level is lower than the MIN
mark, turn the reservoir cap
counterclockwise to open and slowly pour in
the brake fluid to prevent the brake fluid
from overflowing. In case the brake fluid
accidentally spills out, immediately clean it;
otherwise, the spillage may cause damage
to the affected parts in the front
compartment.
Maintenance and Repair
To Next Page
Loading...