EasyManua.ls Logo

Proton e.MAS 7 - Child Safety Lock

Default Icon
246 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
restraint system, make sure to strictly follow
the instructions of manufacturer.
The ISOFIX anchorage mountings are
designed only to carry the load imposed by
the proper installed ISOFIX child restraint
system. In any case, it must not be used as
a seat belt, a place to tie things and other
devices to be attached to a vehicle.
Install the child restraint system only when
the vehicle is stationary. When the ISOFIX
child restraint system is correctly installed to
the ISOFIX anchorage mountings, a
click sound will be heard.
Child Safety Lock
The left and right rear doors are fitted with
child safety locks. Please use child safety
locks when rear seats are occupied with
children.
The child safety lock switch is located on the
outer edge of rear door; toggle the safety
lock switch in the arrow direction as shown
in the figure, then the child safety lock will
be in lock position at this moment; the door
cannot be opened from the inside but can
be opened from the outside to protect the
safety of children.
After setting the child safety lock,
confirm whether the rear door can be
opened or not from inside to make sure the
child safety lock works normally.
Safe Travel

Table of Contents