37
mountings are used to install the ISOFIX
child restraint system on the rear seat. It is
not necessary to install the child restraint
system with a seat belt at this time. When
installing and using the ISOFIX child
restraint system, please follow the
instructions of the manufacturer. Otherwise,
the protection effectiveness may be
affected.
Confirm with the manufacturer
whether the child restraint system can
be used for this type.
Install the child restraint system to the as
follows:
1. Lower the headrest of the rear seat to its
lowest position;
2. Confirm the position of the ISOFIX
anchorage mountings in the rear end of
the rear seat cushion;
3. Align the ISOFIX connector of child
restraint system with the corresponding
ISOFIX mountings and insert it;
4. Confirm that the low anchorage is
buckled firmly;
5. Confirm the position of the top tether
ISOFIX anchorage on the back of the
seatback of rear seat;
6. Align the top tether ISOFIX connector of
child restraint system with the
corresponding top tether ISOFIX
mountings and insert it;
7. Confirm that the top tether anchorage is
buckled firmly;
Confirm that the top tether anchorage
is buckled firmly. Push and pull the
child restraint system in different directions
to check whether it is secured. Installation
shall be carried out according to the
instruction of manufacturer.
If the child restraint system is not
installed to the ISOFIX anchorage
mountings correctly, it may not work
properly. Severe injury or even death may
occur to the child. When mounting a child
Safe Travel
To Next Page
Loading...