EasyManua.ls Logo

Proton e.MAS 7 - Interior Cleaning

Default Icon
246 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
192
Interior Cleaning
Regular vehicle interior cleaning helps to
improve the condition inside the vehicle
cabin. Within certain period of time, dust
and dirt may easily accumulate on interior
trims such as carpet, fabrics, leather and
plastic surfaces, and can cause defect these
trims if it is left for a long time. Any stains
should be cleaned immediately, especially
on light-colored interior trims, as they may
become solid rapidly under extremely high
temperature.
Remove any accumulated dust on small
buttons and knobs with a handy soft brush.
Only use certified cleaning solvent to clean
the interior trim surface. Otherwise, it may
cause permanent defect to the vehicle. It is
necessary to spray cleaner directly on the
cleaning cloth to avoid spraying excessively.
Wipe off the cleaning solvent immediately if
you accidentally spray it on the surface of
other parts in the vehicle.
The temperature of heat blower used to
install tinted film is extremely high. Do not
use the heat blower on the interior trims
when installing the tinted film; otherwise, the
affected interior trims will damage. Before
installing tinted film, make sure all gaps
have been sealed to prevent water stains
from flowing into the gaps and cause
electrical failure.
When you clean the glass surface on
the vehicle, do not use abrasive
cleaning solvents; otherwise, the glass can
get scratched and/or the rear windshield
defogger will damage. Only use soft cloth
and certified glass cleaning solvent.
Detergent contains solvent which may
coagulate on vehicle interior trims. Please
read and comply with all safety instructions
on the labels before using detergent.
Open doors and windows to keep good
ventilation when cleaning the vehicle interior
trims.
Take note the following when cleaning the
interior trims:
Do not clean dirt on trim surface with a
knife blade or other sharp objects.
Do not use a scrubbing brush to clean;
otherwise, the interior surface may
damage.
Do not wipe the trim surface with strong
force; it may not improve the cleaning
effect but will damage the interior trims
instead.
Only use mild neutral soap. Avoid using
strong detergent or degreaser soap. Too
much soap may leave stains and easy to
absorb dirt.
Do not soak the interior trims when
cleaning.
Do not use organic solvents such as
naphtha or alcohol; otherwise, these
solvents will damage the interior trims.
Fabric/Carpet
For dust and dirt, clean them with vacuum
cleaner fitted with soft broom head. For
stubborn stains, try to remove them with
clean water or soda water first. Before
cleaning, use a proper method to remove
these stains:
For liquid stains: Wipe residual stains
gently with tissue to fully saturate and
absorb the liquid stain on the tissue.
Maintenance and Repair

Table of Contents