194
Fault of Headlamps
This vehicle is equipped with LED
headlamps. If any abnormalities or
damages are found in the headlights, go to
the PROTON e.MAS service outlet for
inspection or replacement if necessary.
When there is a temperature
difference between inside and outside
of the combination lamp lens, such as when
in rainy days or when washing the vehicle;
the inside lens may temporarily get foggy.
This is normal. The fog will momentarily
dissipate after you turn on the headlamps. If
the fog does not dissipate, contact an
authorised PROTON e.MAS service outlet
for countermeasure.
Replacement of Fuse
Inspection and Replacement of
Fuse
The following maintenance method can only
be performed by certified well trained
technician. If you are not qualified to
perform these procedures, please consult
your authorised PROTON e.MAS service
outlet for maintenance whenever possible.
If any electrical components are not
working, it is possible that the fuse has
blown. If this happens, it is recommended to
check as follows and replace the fuse if
necessary:
1. Turn off all electrical equipment, switch
the vehicle power mode to OFF
position;
2. Shift the gear in Park (P), with the
vehicle in a non high-voltage state and
the vehicle stationary. Open the front
compartment hood, pull out the red 10A
BECM fuse, close the doors, press the
lock button/car search button on the
intelligent key and put the vehicle power
to OFF position. Wait at least 5 minutes
to ensure the high-voltage system is
fully powered off;
Maintenance and Repair
To Next Page
Loading...