139
takeover is required (such as pressing
brake pedal), the preceding vehicle
image will turn to red.
4. Following Distance (Headway)
It is divided into three levels: near,
medium and far. Every time the vehicle
is started, the time interval for ICC is far
by default.
Headway has three levels: near,
medium and far. Every time the vehicle
is started, the default headway for ICC
system is the far level.
5. Lane Shading
The indicator is in low light if the ICC is
not activated. It is in high light (bright
illumination) if ICC is activated.
6. Lane line
No lane line is displayed when ICC does
not detect any lane line. When ICC
system is not activated, the lane line is
displayed in grey or white
When the ICC is activated, the lane line
is displayed in blue. Red when the lane
departure warning is triggered and the
vehicle deviates from the lane.
In addition, if ACC or ICC has not been
activated during vehicle power mode ON
cycle, and the vehicle speed is below 30 km/
h, the set cruise speed displayed in the
meter instrument is 30 km/h.
When the speed of the vehicle is above 30
km/h, the set cruise speed changes with the
speed shown at meter instrument (current
vehicle speed).
In any case, the driver must keep
sufficient braking distance from the
preceding vehicle and follow relevant
requirements of local highway traffic
regulations on the minimum distance or the
shortest headway distance. It is the
driver’s responsibility to abide by the law.
Offset Control
For vehicles with offset control function,
when the vehicle wants to overtake the
preceding truck, trailer or other large vehicle
(or be overtaken by a large vehicle) with the
intelligent cruise control system activated,
the system controls the vehicle to actively
stay away from the large vehicle in its own
lane, and controls the vehicle to return to the
middle of its own lane again after overtaking
a certain distance. This process does not
require any operation by the driver.
This function can only be
automatically turned on when the
vehicle speed exceeds 50 km/h, and it is the
driver's responsibility to keep his hand on
the steering wheel and concentrate on
driving.
Steering Release Warning
When the intelligent cruise control system is
activated, it requires you to hold the steering
wheel in your hand. If hands are not
detected on the steering wheel for a long
time, relevant reminder messages will
appear on the meter instrument display.
When both hands are detected, the
relevant reminder messages will
disappear and the intelligent cruise control
system will continue to work.
Driving Assist
To Next Page
Loading...