221
Jump Starting
If the vehicle cannot be started due to
weak or flat low-voltage battery, a
jump start method (using another vehicle
and a jumper cable) can be performed to
start the vehicle.
Do not intend to start the vehicle by
pushing or pulling; use only a low-
voltage battery for jump start.
Method 1: Direct to the low-
voltage battery
The following method can only be
performed by certified well trained
technician. If you are not qualified to
perform these procedures, please contact
your authorised PROTON e.MAS service
outlet for assistance whenever possible.
1. Turn the vehicle power mode to OFF
position. Turn off all lamps and electric
accessories, except turning on the
hazard warning lamp (if necessary);
2. Remove the trim cover under the front
centre console of instrument panel and
locate the low-voltage battery;
1 – Low-voltage battery with power
2 – Low-voltage battery with weak or flat
battery
3. Connect one end of the red positive
jumper cable to the positive (+) terminal
(A) of the low-voltage battery with weak
or flat battery;
4. Connect another end of the red positive
jumper cable to the positive (+) terminal
(B) of the low-voltage battery with
power;
5. Connect one end of the black negative
jumper cable to the negative (-) terminal
(C) of the low-voltage battery with
power;
6. Connect another end of the black
negative jumper cable to the negative
(-) terminal (D) of the low-voltage
battery with weak or flat battery;
7. Try to turn on/start the vehicle that has
weak or flat battery. If it doesn’t start
after several attempts, contact
authorised PROTON e.MAS service
outlet for assistance.
Method 2: From the jump start
point in front compartment fuse
box
1. Turn the vehicle power mode to OFF
position. Turn off all lamps and electric
accessories, except hazard warning
lamp (if necessary);
Emergency Rescue
To Next Page
Loading...