222
A – Jump start point (in front
compartment fuse box)
A
2. Connect one end of the red positive (+)
jumper cable to the positive (+) jump
start point (A) in the front compartment
fuse box of vehicle with weak or flat
battery;
3. Connect another end of the red positive
jumper cable to positive (+) terminal (B)
of the low-voltage battery of vehicle with
good battery.
Do not let another end of the red
positive (+) jumper cable contacts
other metal parts.
4. Connect one end of the black negative
(-) jumper cable to the negative (-)
terminal (C) of the low-voltage battery of
vehicle with good battery.
Do not let another end touch anything
before proceeding to next step.
D – Ground point (on vehicle body)
5.
Connect another end of the black
negative (-) jumper cable to the ground
point (D) on the body of the vehicle with
good battery as shown above. Confirm
that the connection has been securely
connected to prevent sparks when
attempting to start;
6. Start the vehicle that has good battery
and keep the vehicle idle for at least
four minutes;
7. Try to start the vehicle that has weak or
flat battery. If it fails to start with a few
attempts, the vehicle will likely need to
be repaired.
If the jumper cable is connected or
removed in wrong sequence, a short
circuit may occur and the vehicle may be
damaged. Repair caused thereby is not
covered by warranty. Therefore, it is
Emergency Rescue
To Next Page
Loading...