36
Push or pull the child restraint system from
different directions to confirm it is firmly fixed
and it must be installed according to the
instructions provided by manufacturer.
Installation of Booster Seat
Below is a generic method to install a
booster seat child restraint system.
PROTON recommends child restraint
system is installed according to the
manufacturer handbook.
Put the child in the child safety seat, pass
the lap belt and the shoulder belt through or
around the child, insert the latch into the
buckle and do not twist the seat belt
according to instructions of the child
restraint system.
Confirm that the shoulder belt passes
through the shoulder of child, and try to
keep the lap belt as low as to the hip/lap of
child. Please refer to Section “Seat Belt”
in this Chapter for details. To remove the
child restraint system, press the release
button of the buckle. Let the seat belt retract
back, and the seat belt will be functioning as
usual.
Make sure the shoulder belt is at the
middle of child’s shoulder. Keep the
seat belt away from the neck of child but do
not have the seat belt be located below
child’s shoulder. Otherwise, the protective
effect may be reduced and serious injuries
may be caused in an accident.
An incorrect positioned lap belt (positioned
higher than child hip) and a loose fitting seat
belt may cause serious injuries in a collision.
Confirm the lap belt is kept as low as to the
hip/lap of child. For child’s safety, do not
put the shoulder belt below the child’s arm.
Installation of ISOFIX Child
Restraint System
Dedicated ISOFIX mountings are located in
the rear end of the rear seat cushion. These
Safe Travel
To Next Page
Loading...