35
Installation of Seat Belt Based
Forward-facing CRS
Below is a generic method to install a front-
facing seat belt based child restraint system.
PROTON recommends child restraint
system is installed according to the
manufacturer handbook.
Pass the lap belt and the shoulder belt
through or around the child restraint system,
insert the latch into the buckle, do not twist
the seat belt and tighten the lap belt.
Pull the shoulder belt fully to locking state
and it cannot be pulled out when the
shoulder belt retracts a little. Before the seat
belt retracts, please make sure it is getting
into locking state, so as to fix the child
restraint system firmly in place.
When pressing the child restraint system to
the cushion and the backrest, let the
shoulder belt retract completely to fix the
child seat firmly.
Safe Travel
To Next Page
Loading...