34
restraint system, please install it in the left
rear seat.
Below is a generic method to install a rear-
facing seat belt based child restraint system.
PROTON recommends child restraint
system is installed according to the
manufacturer handbook. Pass the three-
point seat belt through or embrace around
the child restraint system, insert the latch
into the buckle and do not twist the seat belt
according to instructions of the child
restraint system. Keep the lap belt uptight.
Be sure to confirm latch and buckle
are locked and the seat belt is not
twisted after the latch is inserted.
Do not insert any coin or clip etc. into the
buckle to avoid obstructing the latch being
inserted into the buckle properly. If the
buckle is not functioning properly,
immediately contact the authorised
PROTON e.MAS service outlet for
inspection and repair.
Do not use the seat before the buckle is
fixed, as it cannot play a role in protecting
the passengers or the child.
Push or pull the child restraint system from
different directions to confirm it is firmly
fixed.
To remove the child restraint system, press
the release button of the buckle.
Safe Travel
To Next Page
Loading...