ULTRA 4 INSTRUCTION MANUAL
132
P2n0 = 1 (Clock)
P2n3 – Relay Setpoint 1
Relay Setpoints are entered in Hours & Minutes (HH:MM) to set Time at
which relay will energise. Default = 00:00 (HH:MM)
P2n4 – Relay Setpoint 2
Relay Setpoints are entered in seconds to set the Time Period that the relay
will remain ‘ON’. Default = 0.00 mins.
P2n0 = 2 (Totaliser)
P2n3 – Relay Setpoint 1
Relay Setpoints are entered as a factor by which the on-board totaliser
(P820) should be multiplied by to provide a relay closure. Default = 0.00
P2n4 – Relay Setpoint 2
Relay Setpoints are entered in seconds to set the Time Period that the relay
will remain ‘ON’. Default = 0.00 secs.
To Next Page
Loading...
