Pulsar Ultra 4 - Common Parameters; Data Log Parameters

PULSAR MEASUREMENT
133
Common Parameters
P2n7– Relay Closures
The Ultra 4 will record how many times each relay has operated, this
parameter displays the number of times the relay has activated since the
relay has been in use. It can be reset with any value.
P2n8 – Relay Fail Safe
The Ultra 4 has a general fail-safe parameter P808. However, this can be
overridden so that each individual relay has its own independent fail-safe
mode.
This parameter determines what the relay will do in the event of the Failsafe
Time (P809) expiring.
OPTION
DESCRIPTION
0 = Default
Relay assumes system default mode set in P808
1 = Hold
Relay remains in its current state
2 = De-energise
Relay will De-energise
3 = Energise
Relay will energise
Data Log parameters
The data log parameters contain the following information:
Data Log Setup
The data logged on to the SD card will depend on the system type currently
in use, at an interval rate which is set in P129 Sample Interval.
P129 Sample Interval
This parameter sets the logging interval a log is sampled from the unit (in
minutes) and stored on to the SD card. Default = 5 minutes