Pulsar Ultra 4 - Service Alarm

ULTRA 4 INSTRUCTION MANUAL
176
P979 End Month
This parameter is used to select the month, in which Daylight-Saving Time
will end.
OPTION
DESCRIPTION
1= January
DST will end during the month of January
2= February
DST will end during the month of February
3=March
DST will end during the month of March
4= April
DST will end during the month of April
5= May
DST will end during the month of May
6= June
DST will end during the month of June
7= July
DST will end during the month of July
8= August
DST will end during the month of August
9= September
DST will end during the month of September
10= October (Default)
DST will end during the month of October
11= November
DST will end during the month of November
12= December
DST will end during the month of December
Service Alarm
An alarm can be raised if the Ultra 4 or the application is due for a service.
P195 Interval
This parameter allows a repeat interval (in days) to be set to indicate the
time between each service. When a service alarm is triggered and reset by
using P199, the new service alarm will activate by the amount of days set in
this parameter. For example, if 365 has been entered, then after a reset is
done the new alarm will automatically be set to activate in 365 days’ time.
At midnight, every day on the unit the interval will reduce until the service
alarm is due. The service alarm relay that is programmed (details of how to
do this are shown in Relays > Alarms section of this manual), changes state
and the square indicator will become solid black.
And when activated a message will appear on the display indicating a service
is due, and will display the following message on the Main run mode screen:
Service due. Call 01684 891371