PULSAR MEASUREMENT
49
use the arrow keys to highlight Pump or press “2” followed by “ENTER” the
message “Saved” followed by “Loading ***” will be displayed and your Ultra
4 will be configured to allow the setup for pump applications.
Confirmation that configuration has been completed will be the unit
returning to the Ultra Wizard selection and the setup you have chosen will
be displayed. You can now continue in the unit advancing to the relevant
“Quick Setup” menu.
For full details on how to programme the Ultra 4 for Pump control, using the
Quick Setup Menu, please proceed to Chapter 6 Pump. For a full description
of all features and parameters please refer to Chapter 8 Parameter Listing
and Description.
Ultra 4 - Flow
If you require to set up a flow application, then use the arrow keys to
highlight Flow or press “3” followed by “ENTER” the message “Saved”
followed by “Loading ***” will be displayed and your Ultra 4 will be
configured to allow the setup for flow applications. Confirmation that
configuration has been completed will be the unit returning to the Ultra
Wizard selection and the setup you have chosen will be displayed. You can
now continue in the unit advancing to the relevant “Quick Setup” menu.
For full details on how to programme the Ultra 4 for flow, using the Quick
Setup Menu, please proceed to Chapter 7 Flow. For a full description of all
features and parameters please refer to Chapter 8 Parameter Listing and
Description.
Programming the controller for Open Channel Flow Measurement (OCM)
provides comprehensive flow monitoring with data logging and control
functions for a complete range of flumes, weirs and channels. Flow
calculations to the British Standard BS3680 are available within the firmware
together with calculations for a wide variety of other primary elements. Also
available within the unit is a customised 32-point calibration routine which
also permits the flow measurement of non - standard flumes and weirs.
To Next Page
Loading...
