Pulsar Ultra 4 - Chapter 6 Pump

ULTRA 4 INSTRUCTION MANUAL
64
CHAPTER 6 PUMP
When Ultra Wizard = 2 Pump
This quick set-up guide shows you how to get up and running within a few
minutes of installing your Ultra 4.
Before proceeding ensure that the Ultra Wizard = 2 Pump (Vantage 3). For
further details, see Chapter 4 Ultra Wizard.
Enter Program Mode
First you need to go from run mode into program mode. Assuming the
passcode is the default 1997, then you should enter this.
Choose Quick Setup
Now you need to go into the quick setup. You will see on the display the
words ‘Ultra Wizard’, press the ‘right hand’ arrow key and this will take you
to the ‘Quick Setup’ menu option. Try pressing either of the two arrow keys
to see some more menu options, but return to Quick Setup, and press
ENTER
1
9
9
7
ENTER
This takes you to the ‘Quick Setup Menu.’
ENTER
This takes you to the common applications
menu, and several options will appear on the
display.
This will appear on the display of the unit,
before pressing Enter.
Pass Code * * * *