Pulsar Ultra 4 - How to Access Program Mode

ULTRA 4 INSTRUCTION MANUAL
38
Program Mode
This mode is used to set up the Ultra 4 or change information already set, by
using the built-in keypad Alternatively, the unit can be set up with a PC via
the RS 232 Serial Interface.
Entering a value for each of the parameters that are relevant to your
application defines all the programming information.
How to Access Program Mode
To enter program mode, you simply enter the passcode, via the keypad,
followed by the ENTER key. The default passcode is 1997, so you would
press the following:
ENTER
1
9
9
7
Pass Code * * * *
This will appear on the display of the unit,
before pressing Enter.
Important Information
There is a time-out period of 30 minutes when in program mode, after
which time run mode will be resumed if you do not press any keys.