PULSAR MEASUREMENT
27
Preparation for Operation
Before switching on, check the following:
✓ The Ultra 4 is mounted correctly and is in a ‘safe’ area.
✓ The power supply is correctly installed.
✓ If powered by AC the protective cover is fitted.
✓ The relays are connected correctly.
✓ Any controlled equipment, e.g., motors, servos & valves, are not able to
injure people or damage property.
Maintenance
There are no user serviceable parts inside Ultra 4, except the mains fuse. If
you experience any problems with the unit, then please contact Pulsar
Measurement for advice.
To clean the equipment, wipe with a damp cloth. Do not use any solvents on
the enclosure.
Important Information
The unique DATEM software comes into operation as soon as power is
applied and is designed to monitor a moving level or target with the
transducer in a fixed position.
If, after any period of use, it should become necessary to move the
transducer, for any reason, from its original operating position, switch off
the Ultra 4, before proceeding, to prevent any undesirable updates to the
DATEM trace. If after moving the transducer the reading is not as expected,
please refer to Chapter 10 Troubleshooting.
To Next Page
Loading...
