PULSAR MEASUREMENT
177
P196 STD Leading zeroes
This parameter is used to enter the number of 0’s that appear at the
beginning of the phone number that is shown on the screen when the
service alarm messages are displayed. For example, enter ‘00’ for an
international number, and enter ‘0’ for a mobile or local STD number.
P197 STD Phone STD code
This parameter is used to enter the ‘STD’ or ‘Area code’ of the phone
number that is shown on the screen when the service alarm messages are
displayed. If ‘00’ or ‘0’ has been entered in ‘P196’ then you do not need to
enter any leading zeroes into this parameter for an STD code or mobile
number. Instead enter the first four digits of the number.
P198 Phone number
This parameter is used to enter the digits of the remaining telephone
number.
P199 Service alarm reset
After the service is carried out, use this parameter to reset the service alarm.
To enable a reset, enter a value of ‘1’ and press ‘Enter’ and the alarm is now
reset. If an Interval (P195) is set, then the service alarm will next activate
according to the value in P195.
P194 Interval remaining
This is a read only parameter and displays how many days are remaining
until the service alarm activates.
Language
P934 Language
This parameter selects the language that the unit can be set up to and
display all information to the language selected. Options are as follows:
1. English (Default)
2. French
3. German
4. Italian
5. Spanish
6. Swedish
To Next Page
Loading...
