Pulsar Ultra 4 - Ultra 4 - Level; Volume; Ultra 4 - Pump control

ULTRA 4 INSTRUCTION MANUAL
48
Ultra 4 - Level / Volume
If you require to set up a level or volume application, with or without a
choice of control functions, use the arrow keys to highlight Level/Volume or
press “1” followed by “ENTER” the message “Saved” followed by “Loading
***” will be displayed and your Ultra 4 will be configured to allow the setup
for level/volume applications. Confirmation that configuration has been
completed will be the unit returning to the Ultra Wizard selection and the
setup you have chosen will be displayed. You can now continue in the unit
advancing to the relevant “Quick Setup” menu.
For full details on how to programme the Ultra 4 for level/volume, using the
Quick Setup Menu, please proceed to Chapter 5 Level/Volume. For a full
description of all features and parameters please refer to Chapter 8
Parameter Listing and Description.
Programming the controller for level/volume, provides the ability to convert
level measurement to enable the contents of a vessel to be displayed in
volume, along with control functions, for a complete range of vessel shapes.
Also available within the unit is a customised 32-point calibration routine
which also permits the calculation of volume in non - standard vessels.
The Ultra 4 can measure from zero to 40 m from the face of the transducer
to the surface being monitored, dependent on the transducer used. Details
of level, space, distance, and units of volume can be shown on the display.
The four user-definable relays with individual setpoints can be programmed
to activate devices such as pumps or other control equipment.
The 4-20 mA output is fully programmable to provide an output relative to
level, space, distance or volume of the application being measured.
Ultra 4 - Pump control
Programming the controller for pump control, provides a complete range of
pump “duties” readily available to the user.
The Ultra 4 can measure from zero to 40m from the face of the transducer to
the surface being monitored, dependent on the transducer used. Details of
level, space or distance can be shown on the display. The four user
definable relays with individual setpoints can be programmed to activate
alarms, pump starters, or other control equipment.
The 4-20 mA output is fully programmable to provide an output relative to
level, space, or distance. If you require to set up a pump application, then