PULSAR MEASUREMENT
65
Pump Application
When Ultra Wizard = 2, Pump there are two categories of application, which
are all described later in this manual. They are pump down (sump control) or
pump up (reservoir control) all with the choice of alarms.
If you want to set-up a basic level monitoring application, as described in
example 4, then choose option 1.
If you want to set-up a pump down (sump control) application, as described
in example 5 then choose option 2.
If you want to set-up a pump up (reservoir control) application, as described
in the following example 6 then choose option 3.
Once you have chosen your application you will be asked a series of
questions which are answered by choosing the appropriate option as
detailed in the flow chart on the following page. Once all the parameters
have been set in the quick setup you can return to run mode, or alternatively
if you have more advanced parameters to setup you can access these
through the menu system, to complete the programming of the unit.
To Next Page
Loading...
