Pulsar Ultra 4 - Page 148

ULTRA 4 INSTRUCTION MANUAL
148
P706 Volume Units
Select the Volume Units to be used to display and calculate the flow rate
from the options below:
OPTION
DESCRIPTION
1 = Litres (Default)
Flow units will be calculated and displayed in Litres
2 = Cubic metres
Flow units will be calculated and displayed in m
3
3 = Cubic feet
Flow units will be calculated and displayed in Ft
3
4 = UK Gallons
Flow units will be calculated and displayed in UK Galls
5 = US Gallons
Flow units will be calculated and displayed in US Galls
6 = Mil. USG
Flow units will be calculated and displayed in Millions
US Galls
P707 Time Units
Select the Time Units to be used with the Volume Units to determine the
desired flow rate from the options below:
OPTION
DESCRIPTION
1 = per Second (Default)
Flowrate will be calculated in and displayed in
volume units/second
2 = per Minute
Flowrate will be calculated in and displayed in
volume units/minute
3 = per Hour
Flowrate will be calculated in and displayed in
volume units/hour
4 = per Day
Flowrate will be calculated in and displayed in
volume units/day
P708 Flow Decimal
This parameter determines the number of decimal places in the flow rate
reading during run mode. It can be set between 1 and 3. Default = 2
P709 Flow Cut Off
This parameter is used to select the minimum flow, in a % of flow rate, which
is to be totalised. Enter values in % of maximum flow. Default = 5%