PULSAR MEASUREMENT
17
All electronic products are susceptible to electrostatic shock, so follow
proper grounding procedures during installation.
When forming part of a system used in a hazardous area, the Ultra 4 must
be mounted in a non-hazardous (safe) area, and the transducer / sensor
fitted in the hazardous area.
Appropriate safety precautions must be taken (IECEx / ATEX / FM).
Exia (I.S.) installations require a safety barrier and protective earth.
Exmb installations require protected cable runs and adequate fusing.
Refer to local regulations and standards for specific requirements.
Important Information
All electronic products are susceptible to electrostatic shock, so follow proper
grounding procedures during installation.
To Next Page
Loading...
