quadient iX-7PRO Series - How to Set [Redate] Mode Printing

2. Insert the mail piece into the mail path against the rear-guide wall, side to be
printed facing upwards.
The Mailing System applies the imprint and the mail piece is sent to the catch tray.
How to Set [Redate] Mode printing
If you have a mail piece that has been stamped with a date that is not the actual date
you are mailing the piece, you must “Redate” the mail piece before mailing. Redating
is done by applying a “0” value date correction indicia (stamp) to the envelope / item.
• USPS postal regulations state that the indicia (stamp)
must show the actual date the mail is deposited with the
post office. The post office may return mail if the correct
date is not on the indicia.
• Only one date correction indicia (stamp) is permitted.
• On letter size mail, place the date correction indicia (stamp)
on the non-address side of the envelope in the upper right
corner.
• If the date stamp is printed on a label, it may be placed
on the address side of the envelope in the lower left corner.
3
Processing Mail
81
| Page 81 | Apr-15-2022 12:02 |