October, 1996 6880902Z36-B 6-13
GM300 Radio Service Software Manual Accessory Connector (16 Channel Models Only)
Customizing the Expanded Accessory Connector
6
Phone Patch
RSS LOCATION
DEFINITION The phone patch interface package was designed for the i50x phone patch, but
can be used with a variety of Motorola and third party phone patches.
DEFAULT/CHOICES Refer to Table 10-23 on page 10-14 in Appendix H for defaults.
DEPENDENCIES The Internal Accessory MUST be set to NONE.
IMPORTANT NOTE Incompatible with DTMF Decoder Board.
RECOMMENDATIONS To avoid any transients that may occur while turning on the radio, we suggest
that the power-up delay be at least 500ms.
SEE ALSO External Accessories, Internal Accessories, DTMF Decoder Board
PROGRAMMING PROCEDURE
1. Press F4 at the MAIN MENU to get to the
CHANGE/VIEW CODEPLUG MENU.
4. Use the ↑ ↓ arrow keys to select Phone Patch.
If the choice does not appear, check that the
Internal Accessory is set to NONE.
2. At the CHANGE/VIEW CODEPLUG MENU,
press F2 to get to the RADIO-WIDE screen.
5. To customize the accessory package, press F9 to
get to the ACCESSORY CONNECTOR CON-
FIGURATION screen and make the desired
changes.
3. Press Tab or Enter/Return until the Acc. Exter-
nal field is highlighted.
MAIN
MENU
➠
F4
➠
F2
CHANGE/
VIEW
➠
Tab
RADIO
WIDE
Acc. External
field
To Next Page
Loading...
