R&S FPC Series - Frequency Menu; Access: [Freq]; See Defining a Center Frequency

Function Reference
R&S
®
FPC
392User Manual 1178.4130.02 ─ 07
Remote command:
Filter state: [SENSe:]DDEMod:FILTer[:STATe] on page 319
Filter type: [SENSe:]DDEMod:FILTer:NAME on page 319
Symbol rate: [SENSe:]DDEMod:SRATe on page 320
Alpha / BT: [SENSe:]DDEMod:FILTer:ALPHa on page 318
Number of symbols: [SENSe:]DDEMod:TIME on page 320
Burst processing: [SENSe:]DDEMod:BURSt[:STATe] on page 318
Standard
See "Selecting a standard" on page 166.
Remote command:
not supported
Eye Diagram
See "Selecting the result display" on page 160.
Remote command:
CALCulate<n>:FEED on page 313
Symbols
See "Selecting the result display" on page 160.
Remote command:
CALCulate<n>:FEED on page 313
Modulation Depth / Modulation Deviation
See "Selecting the result display" on page 160.
Remote command:
CALCulate<n>:FEED on page 313
Modulation Error
See "Selecting the result display" on page 160.
Remote command:
CALCulate<n>:FEED on page 313
20.7.2 Frequency Menu
Access: [Freq]
Center Frequency....................................................................................................... 392
Center Freq Step Size.................................................................................................393
Frequency Offset.........................................................................................................393
Center Frequency
See "Defining a center frequency" on page 94.
Remote command:
[SENSe:]FREQuency:CENTer on page 248
Function Reference: Digital Demodulation