The Receiver Application
R&S
®
FPC
144User Manual 1178.4130.02 ─ 07
15.5 Sweep Configuration
Access: "Sweep"
Access: "Setup" > "Config Overview" > "Bandwidth" (selected settings)
Remote commands to control the measurement:
●
Chapter 19.13.5, "Sweep Control", on page 300
The sweep menu provides settings to control the measurement and the way data is
captured.
Defining the measurement time
The measurement time is the time that the R&S FPC collects data at each measure-
ment frequency to calculate the results for that frequency according to the detector you
have selected.
1. Press the "Sweep" key to open the sweep menu.
2. Select the "Measurement Time" menu item.
3. Define the measurement time you need.
Selecting the measurement mode
When you enter the receiver mode, the R&S FPC repeatedly measures the receive fre-
quency or set of frequencies over the measurement time you have defined. If you want
to measure a fixed frequency or frequency scan only once, select single scan mode.
1. Press the "Sweep" key to open the sweep menu.
2. Select the "Continuous Scan" menu item.
The R&S FPC starts a continuous measurement of the selected receiver frequency
or scan range.
You can interrupt a continuous measurement by selecting the "Continuous Sweep"
menu item again.
3. Select the "Single Scan" menu item.
The R&S FPC starts a single measurement of the selected receiver frequency or
scan range.
15.6 Trace Configuration
Access: "Trace"
Access: "Setup" > "Config Overview" > "Analysis" (selected settings)
Remote commands to configure traces:
●
Chapter 19.13.6, "Traces", on page 300
Trace Configuration
To Next Page
Loading...
Need help?
General
