R&S FPC Series - Function Reference: Digital Demodulation

Function Reference
R&S
®
FPC
391User Manual 1178.4130.02 ─ 07
Audio Beep
See "Turning an audio signal in case of limit violation on and off" on page 157.
Remote command:
CALCulate<n>:LIMit<k>:BEEP[:STATe] on page 289
20.7 Function Reference: Digital Demodulation
Access: [Mode] > "Digital Demod"
● Measurement Menu.............................................................................................. 391
● Frequency Menu................................................................................................... 392
● Amplitude Menu.................................................................................................... 393
● Sweep Menu......................................................................................................... 394
● Trace Menu........................................................................................................... 394
● Marker Menu.........................................................................................................395
20.7.1 Measurement Menu
Access: [Meas]
ASK.............................................................................................................................391
FSK............................................................................................................................. 391
Demod Parameters.....................................................................................................391
Standard......................................................................................................................392
Eye Diagram............................................................................................................... 392
Symbols...................................................................................................................... 392
Modulation Depth / Modulation Deviation................................................................... 392
Modulation Error..........................................................................................................392
ASK
See "Selecting the measurement" on page 159.
Remote command:
[SENSe:]DDEMod on page 317
FSK
See "Selecting the measurement" on page 159.
Remote command:
[SENSe:]DDEMod on page 317
Demod Parameters
●
"Selecting the filter type" on page 164
●
"Defining the symbol rate" on page 165
●
"Defining the roll-off factor of the measurement filter" on page 164
●
"Defining the number of signal symbols" on page 165
●
"Turning burst processing on and off" on page 165
Function Reference: Digital Demodulation