EasyManua.ls Logo

R&S FPC Series - Bandwidth; Sweep

R&S FPC Series
419 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Control
R&S
®
FPC
336User Manual 1178.4130.02 ─ 07
Parameters:
<State> ON | 1
Frequency settings are coupled. When you change the fre-
quency or span in the DTF measurement, they also change in
the other VNA measurements (reflection, transmission and cable
loss).
OFF | 0
Frequency settings of the DTF measurement are independent.
When you change the frequency or span in the DTF measure-
ment, they do not change in the other VNA measurements
(reflection, transmission and cable loss).
*RST: ON
Example: //Decouple frequency and span
FREQ:SETT:COUP:ENAB OFF
Manual operation: See "Coupled Span" on page 399
[SENSe:]FREQuency:SPAN:AUTO
<State>
This command turns the automatic calculation of the ideal span on and off.
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Turn on automatic span
FREQ:SPAN:AUTO ON
Manual operation: See "Manual Span" on page 369
See "Manual Span" on page 399
19.16.4 Bandwidth
Commands to configure the bandwidth described elsewhere.
Resolution bandwidth:
[SENSe:]BANDwidth[:RESolution]
[SENSe:]BANDwidth[:RESolution]:AUTO
19.16.5 Sweep
Commands to configure the sweep described elsewhere.
Sweep mode:
INITiate:CONTinuous
Initiate measurement:
INITiate[:IMMediate]
[SENSe:]SWEep:POINts.................................................................................................337
Remote Commands of the VNA Application

Table of Contents

Related product manuals