R&S FPC Series - Remote Commands of the Receiver Application

Remote Control
R&S
®
FPC
295User Manual 1178.4130.02 ─ 07
Example: //Select the upper limit line.
FREQ:SPAN 0HZ
CALC:LIM:UPP:SEL 'GSM_Upper.rellim'
Usage: Setting only
Manual operation: See "Upper Limit" on page 374
See "Upper Limit" on page 384
See "Upper Limit" on page 402
CALCulate<n>:LIMit<k>:UPPer:THReshold <Level>
This command defines the level of an upper threshold limit line.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<Level> <numeric value>
Unit depends on the unit you have currently selected for the ver-
tical axis.
Example: //Turn on threshold limit line
CALC:LIM:UPP:THR -10DBM
Manual operation: See "Upper Limit" on page 374
See "Upper Limit" on page 384
See "Upper Limit" on page 402
19.13 Remote Commands of the Receiver Application
● Measurement Configuration..................................................................................295
● Frequency............................................................................................................. 296
● Amplitude.............................................................................................................. 299
● Bandwidth............................................................................................................. 299
● Sweep Control.......................................................................................................300
● Traces................................................................................................................... 300
● Marker...................................................................................................................302
19.13.1 Measurement Configuration
DISPlay:BARGraph:PHOLd:RESet.................................................................................. 296
[SENSe:]FREQuency:MODE...........................................................................................296
TRACe[:DATA]?.............................................................................................................296
Remote Commands of the Receiver Application