EasyManua.ls Logo

R&S FPC Series - Limit Lines

R&S FPC Series
419 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Control
R&S
®
FPC
340User Manual 1178.4130.02 ─ 07
DISPlay<n>:IMPedance:REFerence:POSition <Impedance>
This command defines the reference impedance for the Smith chart measurement for-
mat. The impedance can be between 1mΩ and 10 kΩ.
Prerequisites for this command
Select reflection measurement (MEASurement<n>:MODE).
Select Smith chart format (MEASurement<n>:FORMat).
Suffix:
<n>
.
irrelevant
Parameters:
<Impedance> <numeric value>
Range: 1 mOhm to 10 kOhm
*RST: 50 Ohm
Default unit: Ohm
Example: //Define reference impedance
MEAS:MODE REFL
MEAS:FORM SMIT
DISP:IMP:REF:POS
Manual operation: See "Marker Mode" on page 403
19.16.8 Limit Lines
Commands to configure limit lines described elsewhere.
Display lines:
CALCulate<n>:DLINe
CALCulate<n>:DLINe:STATe
Limit line management:
CALCulate<n>:LIMit<k>:COMMent?
CALCulate<n>:LIMit<k>:DEFine
CALCulate<n>:LIMit<k>:DELete
CALCulate<n>:LIMit<k>:UNIT:X?
CALCulate<n>:LIMit<k>:UNIT[:Y]?
Limit checks:
CALCulate<n>:LIMit<k>:BEEP[:STATe]
CALCulate<n>:LIMit<k>:FAIL?
CALCulate<n>:LIMit<k>:LOWer:SELect
CALCulate<n>:LIMit<k>:STATe
CALCulate<n>:LIMit<k>:UPPer:SELect
Threshold lines:
CALCulate<n>:LIMit<k>:LOWer:THReshold
CALCulate<n>:LIMit<k>:UPPer:THReshold
Remote Commands of the VNA Application

Table of Contents

Related product manuals