R&S FPC Series - Page 292

Remote Control
R&S
®
FPC
289User Manual 1178.4130.02 ─ 07
19.12.11 Limit Lines
CALCulate<n>:LIMit<k>:BEEP[:STATe]............................................................................ 289
CALCulate<n>:LIMit<k>:COMMent?................................................................................ 289
CALCulate<n>:LIMit<k>:DEFine......................................................................................290
CALCulate<n>:LIMit<k>:DELete......................................................................................291
CALCulate<n>:LIMit<k>:FAIL?........................................................................................ 291
CALCulate<n>:LIMit<k>:LOWer:SELect........................................................................... 292
CALCulate<n>:LIMit<k>:LOWer:THReshold..................................................................... 292
CALCulate<n>:LIMit<k>:STATe........................................................................................293
CALCulate<n>:LIMit<k>:UNIT:X?.....................................................................................293
CALCulate<n>:LIMit<k>:UNIT[:Y]?...................................................................................294
CALCulate<n>:LIMit<k>:UPPer:SELect............................................................................294
CALCulate<n>:LIMit<k>:UPPer:THReshold...................................................................... 295
CALCulate<n>:LIMit<k>:BEEP[:STATe] <State>
This command turns the beeper that beeps if a limit line is violated on and off.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Activate the audio beep
CALC:LIM:BEEP ON
Manual operation: See "Audio Beep" on page 374
See "Audio Beep" on page 384
See "Audio Beep" on page 391
See "Audio Beep" on page 402
CALCulate<n>:LIMit<k>:COMMent?
This command queries the description of a limit line.
Prerequisites for this command
●
Select a limit line or define a threshold limit with one of the following commands:
– CALCulate<n>:LIMit<k>:LOWer:SELect
– CALCulate<n>:LIMit<k>:LOWer:THReshold
– CALCulate<n>:LIMit<k>:UPPer:SELect
– CALCulate<n>:LIMit<k>:UPPer:THReshold
Suffix:
<n>
.
irrelevant
<k> Limit line
Remote Commands of the Spectrum Application