R&S FPC Series - Amplitude Menu; Reference Level See Defining a Reference Level; Center Freq Step Size; Remote Command

Function Reference
R&S
®
FPC
393User Manual 1178.4130.02 ─ 07
Center Freq Step Size
See "Defining a frequency step size" on page 94.
Remote command:
[SENSe:]FREQuency:CENTer:STEP on page 248
Frequency Offset
See "Defining a frequency offset" on page 95.
Remote command:
[SENSe:]FREQuency:OFFSet on page 250
20.7.3 Amplitude Menu
Access: [Ampt]
Reference Level..........................................................................................................393
Deviation per Division................................................................................................. 393
Ref Position.................................................................................................................393
Preamplifier.................................................................................................................393
Attenuator....................................................................................................................393
Reference Level
See "Defining a reference level" on page 99.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RLEVel on page 253
Deviation per Division
See "Adjusting the scale of the y-axis" on page 167.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:PDIVision on page 321
Ref Position
See "Defining the position of the reference (ASK signals)" on page 167.
(Only for ASK measurements.)
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RPOSition on page 321
Preamplifier
See "Turning the preamplifier on and off" on page 103.
Remote command:
INPut:GAIN:STATe on page 256
Attenuator
See "Defining RF attenuation" on page 101.
Function Reference: Digital Demodulation