R&S FPC Series - Frequency; Amplitude

Remote Control
R&S
®
FPC
320User Manual 1178.4130.02 ─ 07
[SENSe:]DDEMod:SRATe <SymbolRate>
This command defines the symbol rate.
Parameters:
<SymbolRate> <numeric value> (integer only)
Default unit: Hz
Example: //Define symbol rate
DDEM:SRAT 10KHZ
Manual operation: See "Demod Parameters" on page 391
[SENSe:]DDEMod:TIME <Symbols>
This command defines the number of symbols to be evaluated.
Parameters:
<Symbols> <numeric value> (integer only)
Range: 20 to depends on measurement filter
*RST: 100
Example: //Define the number of symbols
DDEM:TIME 150
Manual operation: See "Demod Parameters" on page 391
19.15.3 Frequency
Commands to configure the frequency described elsewhere.
●
Center frequency:
[SENSe:]FREQuency:CENTer
●
Frequency stepsize:
[SENSe:]FREQuency:CENTer:STEP
●
Frequency offset:
[SENSe:]FREQuency:OFFSet
19.15.4 Amplitude
Commands to configure amplitude described elsewhere.
●
Reference level:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RLEVel
●
Preamplifier:
INPut:GAIN:STATe
●
Attenuation:
INPut:ATTenuation
INPut:ATTenuation:AUTO
INPut:ATTenuation:MODE
Remote Commands of the Digital Demodulation