Remote Control
R&S
®
FPC
187User Manual 1178.4130.02 ─ 07
19 Remote Control
● Remote Control Basics......................................................................................... 187
● Common Commands............................................................................................ 202
● Preset....................................................................................................................206
● Network Connection..............................................................................................207
● System Configuration............................................................................................209
● Display Settings.................................................................................................... 215
● Audio Settings.......................................................................................................215
● Data Management.................................................................................................216
● Signal Source Configuartion................................................................................. 226
● Calibration.............................................................................................................228
● Applications...........................................................................................................231
● Remote Commands of the Spectrum Application................................................. 232
● Remote Commands of the Receiver Application.................................................. 295
● Remote Commands of the Analog Demodulation.................................................303
● Remote Commands of the Digital Demodulation..................................................313
● Remote Commands of the VNA Application......................................................... 323
● Status Reporting System...................................................................................... 341
19.1 Remote Control Basics
● Introduction........................................................................................................... 187
● Remote Control Connection..................................................................................190
● Instrument Model and Command Processing.......................................................191
● SCPI Command Structure.....................................................................................192
● Command Sequence and Synchronization...........................................................200
● Suffix Overview..................................................................................................... 202
19.1.1 Introduction
The R&S FPC supports two different interfaces for remote control.
●
LAN Interface
The protocol is based on TCP/IP and supports the VXI-11 standard.
●
USB Interface
The connectors for both interfaces are on the rear panel of the R&S FPCand allow for
a connection to a controller for remote control via a local area network (LAN) or directly
via USB.
SCPI
SCPI (Standard Commands for Programmable Instruments) commands - messages -
are used for remote control. Commands that are not taken from the SCPI standard fol-
low the SCPI syntax rules. The instrument supports the SCPI version 1999. The SCPI
standard is based on standard IEEE 488.2 and aims at the standardization of device-
Remote Control Basics
To Next Page
