R&S FPC Series - Attenuator; Deviation Per Division; Preamplifier

Function Reference
R&S
®
FPC
389User Manual 1178.4130.02 ─ 07
Deviation per Division
See "Adjusting the scale of the y-axis (AM signals)" on page 151 and "Adjusting the
scale of the y-axis (FM signals)" on page 151.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:PDIVision on page 309
Scale Adjust
See "Adjusting the scale of the y-axis (FM signals)" on page 151.
(Only for measurements on FM signals.)
Remote command:
not supported
Preamplifier
See "Turning the preamplifier on and off" on page 103.
Remote command:
INPut:GAIN:STATe on page 256
Attenuator
See "Defining RF attenuation" on page 101.
Remote command:
Attenuation: INPut:ATTenuation on page 255
Automatic attenuation: INPut:ATTenuation:AUTO on page 255
Attenuation mode: INPut:ATTenuation:MODE on page 256
Impedance
See "Selecting the input impedance" on page 98.
Remote command:
Impedance: INPut:IMPedance on page 256
Matching pad:INPut:IMPedance:PAD on page 257
20.6.4 Bandwidth Menu
Access: [BW]
Manual DBW...............................................................................................................389
FM Broadcast..............................................................................................................389
Reference Deviation....................................................................................................390
Manual DBW
See "Selecting the demodulation bandwidth" on page 152.
Remote command:
[SENSe:]ADEMod:BANDwidth:DEModulation on page 310
FM Broadcast
See "Selecting the FM broadcast time" on page 153.
Function Reference: Analog Demodulation