EasyManua.ls Logo

R&S FPC Series - Page 313

R&S FPC Series
419 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Control
R&S
®
FPC
310User Manual 1178.4130.02 ─ 07
[SENSe:]ADEMod:BWIDth:DEModulation <Bandwidth>
[SENSe:]ADEMod:BANDwidth:DEModulation <Bandwidth>
This command selects the demodulation bandwidth.
Parameters:
<Bandwidth> <numeric value> (integer only)
Refer to the datasheet for a list of supported bandwidths.
*RST: 200 kHz
Default unit: Hz
Example: //Select demodulation bandwidth
ADEM:BAND:DEM 50KHZ
Manual operation: See "Manual DBW" on page 389
[SENSe:]ADEMod:BWIDth:RDEViation
<Deviation>
[SENSe:]ADEMod:BANDwidth:RDEViation <Deviation>
This command defines the reference deviation for FM signals.
Prerequisites for this command
Select FM measurements (CALCulate<n>:FEED).
Parameters:
<Deviation> <numeric value>
*RST: 100 kHz
Default unit: Hz
Example: //Define reference deviation
CALC:FEED 'XTIM:FMS'
ADEM:BAND:RDEV 75KHZ
Manual operation: See "Reference Deviation" on page 390
[SENSe:]FILTer:DEMPhasis[:STATe] <State>
This command turns the deemphasis filter on and off.
You can select the time constant of the filter with [SENSe:]FILTer:DEMPhasis:
TCONstant.
Prerequisites for this command
Select 200 kHz or 300 kHz demodulation bandwidth ([SENSe:]ADEMod:
BANDwidth:DEModulation).
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF
Example: //Turn on deemphasis filter
ADEM:BAND:DEM 300KHZ
FILT:DEMP ON
Remote Commands of the Analog Demodulation

Table of Contents

Related product manuals