R&S FPC Series - Page 291

Remote Control
R&S
®
FPC
288User Manual 1178.4130.02 ─ 07
Example: //Set the volume to 40%.
SYST:AUD:VOL 0.40
Manual operation: See "Marker Demodulation" on page 375
See "Marker Demodulation" on page 385
19.12.10 Display Lines
CALCulate<n>:DLINe.....................................................................................................288
CALCulate<n>:DLINe:STATe...........................................................................................288
CALCulate<n>:DLINe <LinePosition>
This command defines the position of a display line.
Prerequisites for this command
●
Turn on a display line (CALCulate<n>:DLINe:STATe).
Suffix:
<n>
.
irrelevant
Parameters:
<LinePosition> <numeric value>
You can use any unit you want, the R&S FPC then converts the
unit to the currently selected unit. If you omit a unit, the
R&S FPC uses the currently selected unit.
*RST: - (STATe to OFF)
Default unit: -
Example: //Position display line
CALC:DLIN:STAT ON
CALC:DLIN –20dBm
Manual operation: See "Display Line" on page 373
See "Display Line" on page 402
CALCulate<n>:DLINe:STATe <State>
This command turns display lines on and off.
Suffix:
<n>
.
irrelevant
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Turn on display line
CALC:DLIN:STAT ON
Manual operation: See "Display Line" on page 373
See "Display Line" on page 402
Remote Commands of the Spectrum Application