R&S FPC Series - Page 406

Function Reference
R&S
®
FPC
403User Manual 1178.4130.02 ─ 07
Remote command:
CALCulate<n>:LIMit<k>:BEEP[:STATe] on page 289
20.8.9 Marker Menu
Access: [Mkr]
Marker <x>..................................................................................................................403
Marker Type................................................................................................................ 403
Marker Mode...............................................................................................................403
All Markers Off.............................................................................................................403
Marker <x>
See "Positioning a marker" on page 121 and "Adding additional markers" on page 121.
Remote command:
Marker state: CALCulate<n>:MARKer<m>[:STATe] on page 278
Marker position (x-axis): CALCulate<n>:MARKer<m>:X on page 279
Marker position (y-axis): CALCulate<n>:MARKer<m>:Y? on page 339
Delta marker state: CALCulate<n>:DELTamarker<m>[:STATe] on page 273
Delta marker position (x-axis): CALCulate<n>:DELTamarker<m>:X on page 273
Delta marker position (relative): CALCulate<n>:DELTamarker<m>:X:RELative
on page 274
Delta marker position (y-axis): CALCulate<n>:DELTamarker<m>:Y? on page 275
Marker Type
See "Selecting the marker type" on page 122.
Remote command:
With corresponding syntax MARKer or DELTamarker
Marker Mode
See "Using markers in the Smith diagram" on page 185.
(Only in Smith diagrams.)
Remote command:
Mode: CALCulate<n>:MARKer<m>:MODE on page 338
Reference impedance: DISPlay<n>:IMPedance:REFerence:POSition
on page 340
All Markers Off
See "Removing markers or delta markers" on page 122.
Remote command:
Markers: CALCulate<n>:MARKer<m>:AOFF on page 275
Delta markers: CALCulate<n>:DELTamarker<m>:AOFF on page 271
20.8.10 Marker To Menu
Access: [Mkr →]
Function Reference: Vector Network Analyzer