R&S FPC Series - Page 277

Remote Control
R&S
®
FPC
274User Manual 1178.4130.02 ─ 07
If necessary, the corresponding delta marker is activated first.
Suffix:
<n>
.
irrelevant
<m> Marker
Parameters:
<Position> <numeric value>
The unit depends on the measurement and marker input mode.
Hz for measurements in the frequency domain.
s for measurements in the time domain.
No unit for channel input mode (CALCulate<n>:MARKer<m>:
FREQuency:MODE).
Example: //Delta marker positions are relative to marker 1.
CALC:DELT:MOD REL
//Position delta marker 2 10.7 MHz to the right of marker 1.
CALC:DELT2:X 10.7MHz
//Query the absolute and relative position of delta marker 2.
CALC:DELT2:X?
CALC:DELT2:X:REL?
Manual operation: See "Marker <x>" on page 374
See "Marker <x>" on page 384
See "Marker <x>" on page 395
See "Marker <x>" on page 403
CALCulate<n>:DELTamarker<m>:X:RELative <Position>
This command positions a delta marker on a position relative to the reference marker.
If necessary, the corresponding delta marker is activated first.
Suffix:
<n>
.
irrelevant
<m> Marker
Parameters:
<Position> <numeric value>
The unit depends on the measurement and marker input mode.
Hz for measurements in the frequency domain.
s for measurements in the time domain.
No unit for channel input mode (CALCulate<n>:MARKer<m>:
FREQuency:MODE).
Example: //Set the delta marker at a distance of 5 kHz to the reference
position.
CALC:DELT3:X:REL 5 kHz
Remote Commands of the Spectrum Application