Remote Control
R&S
®
FPC
259User Manual 1178.4130.02 ─ 07
Parameters:
<Unit> DBM | DBUV | DBMV | V | W | DUVM | DUAM | V_M | W_M2
Note that the availability of units depends on the operating
mode.
*RST: dBm
Example: //Select displayed unit
UNIT:POW DBUV
Manual operation: See "Unit" on page 370
See "Unit" on page 381
19.12.4 Bandwidth
[SENSe:]BWIDth[:RESolution].........................................................................................259
[SENSe:]BANDwidth[:RESolution]................................................................................... 259
[SENSe:]BWIDth[:RESolution]:AUTO...............................................................................260
[SENSe:]BANDwidth[:RESolution]:AUTO..........................................................................260
[SENSe:]BWIDth:VIDeo..................................................................................................260
[SENSe:]BANDwidth:VIDeo............................................................................................ 260
[SENSe:]BWIDth:VIDeo:AUTO........................................................................................260
[SENSe:]BANDwidth:VIDeo:AUTO...................................................................................260
[SENSe:]BWIDth[:RESolution] <Bandwidth>
[SENSe:]BANDwidth[:RESolution] <Bandwidth>
This command selects the resolution bandwidth (or measurement bandwidth).
Effects of this command
●
Turns off automatic selection of resolution bandwidth ([SENSe:]BANDwidth[:
RESolution]:AUTO).
Parameters:
<Bandwidth> <numeric value> (integer)
Value adjustable in 1 - 3 steps (1 Hz, 3 Hz, 10 Hz, etc.).
In addition, you can select a 200 kHz bandwidth.
Range: 1 Hz to 3 MHz
*RST: - (AUTO is set to ON)
Default unit: Hz
Example: //Define resolution bandwidth
BAND 100KHZ
Manual operation: See "RBW: Manual" on page 371
See "RBW: Manual" on page 381
See "RBW: Manual" on page 400
Remote Commands of the Spectrum Application
To Next Page
Loading...
