R&S FPC Series - Page 373

Function Reference
R&S
®
FPC
370User Manual 1178.4130.02 ─ 07
Attenuator....................................................................................................................370
Impedance.................................................................................................................. 370
Transducer.................................................................................................................. 371
Reference Level
See "Defining a reference level" on page 99.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RLEVel on page 253
Range / Ref Position
See "Defining a display range" on page 104, "Defining the position of the reference
level" on page 100 and "Defining a reference offset" on page 100.
Remote command:
Scale (y-axis): DISPlay<n>[:WINDow]:TRACe<t>:Y:SPACing on page 252
Range (y-axis): DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe] on page 252
Range (automatic): DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:ADJust
on page 253
Reference position: DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RPOSition
on page 254
Reference offset: DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RLEVel:
OFFSet on page 254
Auto Range
See "Defining a display range" on page 104.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:ADJust on page 253
Unit
See "Selecting the display unit" on page 103.
Remote command:
UNIT<n>:POWer on page 258
Preamplifier
See "Turning the preamplifier on and off" on page 103.
Remote command:
INPut:GAIN:STATe on page 256
Attenuator
See "Defining RF attenuation" on page 101.
Remote command:
Attenuation: INPut:ATTenuation on page 255
Automatic attenuation: INPut:ATTenuation:AUTO on page 255
Attenuation mode: INPut:ATTenuation:MODE on page 256
Impedance
See "Selecting the input impedance" on page 98.
Function Reference: Spectrum Application