R&S FPC Series - Page 384

Function Reference
R&S
®
FPC
381User Manual 1178.4130.02 ─ 07
Unit
See "Selecting the display unit" on page 103.
Remote command:
UNIT<n>:POWer on page 258
Preamplifier
See "Turning the preamplifier on and off" on page 103.
Remote command:
INPut:GAIN:STATe on page 256
Attenuator
See "Defining RF attenuation" on page 101.
Remote command:
Attenuation: INPut:ATTenuation on page 255
Automatic attenuation: INPut:ATTenuation:AUTO on page 255
Attenuation mode: INPut:ATTenuation:MODE on page 256
Impedance
See "Selecting the input impedance" on page 98.
Remote command:
Impedance: INPut:IMPedance on page 256
Matching pad:INPut:IMPedance:PAD on page 257
Transducer
See "Selecting transducer factors" on page 105.
Remote command:
Selection: [SENSe:]CORRection:TRANsducer<td>:SELect on page 257
State: [SENSe:]CORRection:TRANsducer<td>[:STATe] on page 258
20.5.4 Bandwidth Menu
Access: [BW]
RBW: Manual..............................................................................................................381
CISPR BW: Manual.....................................................................................................381
CISPR BW: Auto.........................................................................................................382
RBW: Manual
See "Selecting the bandwidth" on page 143.
Remote command:
[SENSe:]BANDwidth[:RESolution] on page 259
CISPR BW: Manual
See "Selecting the bandwidth" on page 143.
Remote command:
[SENSe:]BANDwidth[:RESolution]:CISPr on page 299
Function Reference: Receiver Application